U-Boot 1.1.4 (May 3 2012 - 22:04:42) AP121 (ar9330) U-boot DRAM: 16 MB led turning on for 1s... id read 0x100000ff flash size 8388608, sector count = 128 Flash: 8 MB Using default environment In: serial Out: serial Err: serial Net: ag7240_enet_initialize... No valid address in Flash. Using fixed address No valid address in Flash. Using fixed address : cfg1 0x5 cfg2 0x7114 eth0: 00:03:7f:09:0b:ad ag7240_phy_setup eth0 up : cfg1 0xf cfg2 0x7214 eth1: 00:03:7f:09:0b:ad athrs26_reg_init_lan ATHRS26: resetting s26 ATHRS26: s26 reset done ag7240_phy_setup eth1 up eth0, eth1 Autobooting in 3 seconds ## Booting image at 9f020000 ... Uncompressing Kernel Image ... OK Starting kernel ... [ 0.000000] Linux version 3.3.8 (blogic@Debian-60-squeeze-64-minimal) (gcc version 4.6.3 20120201 (prerelease) (Linaro GCC 4.6-2012.02) ) #1 Sun Nov 18 04:31:55 UTC 2012 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU revision is: 00019374 (MIPS 24Kc) [ 0.000000] SoC: Atheros AR9330 rev 1 [ 0.000000] Clocks: CPU:400.000MHz, DDR:400.000MHz, AHB:200.000MHz, Ref:25.000MHz [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 01000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Zone PFN ranges: [ 0.000000] Normal 0x00000000 -> 0x00001000 [ 0.000000] Movable zone start PFN for each node [ 0.000000] Early memory PFN ranges [ 0.000000] 0: 0x00000000 -> 0x00001000 [ 0.000000] Built 1 zonelists in Zone order, mobility grouping off. Total pages: 4064 [ 0.000000] Kernel command line: board=TL-WR703N console=ttyATH0,115200 rootfstype=squashfs,jffs2 noinitrd [ 0.000000] PID hash table entries: 64 (order: -4, 256 bytes) [ 0.000000] Dentry cache hash table entries: 2048 (order: 1, 8192 bytes) [ 0.000000] Inode-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 12764k/16384k available (2209k kernel code, 3620k reserved, 412k data, 212k init, 0k highmem) [ 0.000000] SLUB: Genslabs=9, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS:51 [ 0.000000] Calibrating delay loop... 265.42 BogoMIPS (lpj=1327104) [ 0.080000] pid_max: default: 32768 minimum: 301 [ 0.080000] Mount-cache hash table entries: 512 [ 0.090000] NET: Registered protocol family 16 [ 0.090000] gpiochip_add: registered GPIOs 0 to 29 on device: ath79 [ 0.100000] MIPS: machine is TP-LINK TL-WR703N v1 [ 0.350000] bio: create slab at 0 [ 0.360000] Switching to clocksource MIPS [ 0.360000] NET: Registered protocol family 2 [ 0.370000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.370000] TCP established hash table entries: 512 (order: 0, 4096 bytes) [ 0.370000] TCP bind hash table entries: 512 (order: -1, 2048 bytes) [ 0.380000] TCP: Hash tables configured (established 512 bind 512) [ 0.390000] TCP reno registered [ 0.390000] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.400000] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.400000] NET: Registered protocol family 1 [ 0.430000] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.430000] JFFS2 version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.440000] msgmni has been set to 24 [ 0.440000] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254) [ 0.450000] io scheduler noop registered [ 0.450000] io scheduler deadline registered (default) [ 0.460000] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled [ 0.470000] ar933x-uart: ttyATH0 at MMIO 0x18020000 (irq = 11) is a AR933X UART [ 0.480000] console [ttyATH0] enabled, bootconsole disabled [ 0.480000] console [ttyATH0] enabled, bootconsole disabled [ 0.490000] m25p80 spi0.0: found en25q64, expected m25p80 [ 0.500000] m25p80 spi0.0: en25q64 (8192 Kbytes) [ 0.500000] 5 tp-link partitions found on MTD device spi0.0 [ 0.510000] Creating 5 MTD partitions on "spi0.0": [ 0.510000] 0x000000000000-0x000000020000 : "u-boot" [ 0.520000] 0x000000020000-0x0000001097dc : "kernel" [ 0.520000] mtd: partition "kernel" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only [ 0.530000] 0x0000001097dc-0x0000007f0000 : "rootfs" [ 0.540000] mtd: partition "rootfs" must either start or end on erase block boundary or be smaller than an erase block -- forcing read-only [ 0.550000] mtd: partition "rootfs" set to be root filesystem [ 0.560000] mtd: partition "rootfs_data" created automatically, ofs=2E0000, len=510000 [ 0.570000] 0x0000002e0000-0x0000007f0000 : "rootfs_data" [ 0.570000] 0x0000007f0000-0x000000800000 : "art" [ 0.580000] 0x000000020000-0x0000007f0000 : "firmware" [ 0.600000] ag71xx_mdio: probed [ 0.610000] eth0: Atheros AG71xx at 0xb9000000, irq 4 [ 1.160000] ag71xx ag71xx.0: eth0: connected to PHY at ag71xx-mdio.1:04 [uid=004dd041, driver=Generic PHY] [ 1.170000] TCP cubic registered [ 1.170000] NET: Registered protocol family 17 [ 1.180000] Bridge firewalling registered [ 1.180000] 8021q: 802.1Q VLAN Support v1.8 [ 1.190000] VFS: Mounted root (squashfs filesystem) readonly on device 31:2. [ 1.200000] Freeing unused kernel memory: 212k freed - preinit - Press the [f] key and hit [enter] to enter failsafe mode [ 5.160000] eth0: link up (100Mbps/Full duplex) - regular preinit - [ 6.380000] JFFS2 notice: (436) jffs2_build_xattr_subsystem: complete building xattr subsystem, 1 of xdatum (0 unchecked, 0 orphan) and 12 of xref (0 dead, 2 orphan) found. switching to jffs2 - init - [ 6.490000] eth0: link down Please press Enter to activate this console. [ 8.150000] Compat-drivers backport release: compat-drivers-2012-09-04-2-gddac993 [ 8.160000] Backport based on wireless-testing.git master-2012-09-07 [ 8.160000] compat.git: wireless-testing.git [ 8.200000] cfg80211: Calling CRDA to update world regulatory domain [ 8.200000] cfg80211: World regulatory domain updated: [ 8.210000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 8.210000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 8.220000] cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 8.230000] cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm) [ 8.240000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 8.240000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 8.590000] usbcore: registered new interface driver usbfs [ 8.590000] usbcore: registered new interface driver hub [ 8.600000] usbcore: registered new device driver usb [ 9.160000] ieee80211 phy0: Atheros AR9330 Rev:1 mem=0xb8100000, irq=2 [ 9.170000] cfg80211: Calling CRDA for country: US [ 9.170000] cfg80211: Regulatory domain changed to country: US [ 9.170000] cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp) [ 9.180000] cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm) [ 9.190000] cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm) [ 9.200000] cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 9.210000] cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 9.210000] cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm) [ 9.220000] cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm) [ 9.270000] PPP generic driver version 2.4.2 [ 9.540000] ip_tables: (C) 2000-2006 Netfilter Core Team [ 9.760000] NET: Registered protocol family 24 [ 9.780000] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 9.780000] ehci-platform ehci-platform: Generic Platform EHCI Controller [ 9.790000] ehci-platform ehci-platform: new USB bus registered, assigned bus number 1 [ 9.830000] ehci-platform ehci-platform: irq 3, io mem 0x1b000000 [ 9.850000] ehci-platform ehci-platform: USB 2.0 started, EHCI 1.00 [ 9.850000] hub 1-0:1.0: USB hub found [ 9.850000] hub 1-0:1.0: 1 port detected [ 9.880000] nf_conntrack version 0.5.0 (202 buckets, 808 max) [ 10.340000] ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver [ 14.060000] device eth0 entered promiscuous mode [ 14.410000] eth0: link up (100Mbps/Full duplex) [ 14.410000] br-lan: port 1(eth0) entered forwarding state [ 14.420000] br-lan: port 1(eth0) entered forwarding state [ 16.420000] br-lan: port 1(eth0) entered forwarding state